Agesin DF-D9099 AT is a high-performance, multi-purpose silicone defoamer designed for industrial processes and product performance enhancement. It is specially formulated for foam control in PCB ink (solvent-based) and epoxy floor coating systems. It exhibits excellent bubble-breaking efficiency and rapidly eliminates fine bubbles. Due to its superior performance, the required dosage is significantly lower than that of other defoamers in most systems. Recommended for non-aqueous systems.
AgeSin® DF-D9099 AT
(silicone-based defoamer for solvent-based PCB Ink )
Agesin DF-D9099 AT is a high-performance, multi-purpose silicone defoamer designed for industrial processes and product performance enhancement. It is specially formulated for foam control in PCB ink (solvent-based) and epoxy floor coating systems. It exhibits excellent bubble-breaking efficiency and rapidly eliminates fine bubbles. Due to its superior performance, the required dosage is significantly lower than that of other defoamers in most systems. Recommended for non-aqueous systems.
组成 | Special Organic Polymer Copolymer |
外观 | Light gray translucent liquid |
Solid Content | > 99.0% |
粘度 @ 25°C | 150 – 600 mPa·s |
This data sheet is intended to give typical results, not standard.Subject to COA.
溶剂-based
Excellent bubble-breaking ability
Rapid elimination of fine bubbles
Low dosage requirement
Suitable for non-aqueous systems
Agesin DF-D9099 AT has low solubility in water and lower alcohols but is soluble in benzene, toluene, and mineral oil.
Recommended dosage: 10 – 1000 ppm, depending on the foam-forming substances in the system. For specific systems, dosage may exceed 1%. Optimal dosage should be determined through small-scale testing.
Shake well before use. Can be diluted with recommended solvents.
Printed circuit board (PCB) solvent-based inks
Epoxy floor coatings
Adhesive systems
25 公斤 / 50 公斤/ 200 公斤 Drum
存放于干燥、清洁、通风良好的仓库中.
避免受光照和受热.
运输过程中防止泄漏、雨淋和曝晒.
Keep intact 6 months in original package.Products beyond the storage period may continue to be used after inspection. The container must be closed immediately after use.
